Kit Assembly
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
Introduction
Details
Guide Steps
Review
Quiz
It is important to attach the bolts in the correct order so that all bolts, and correct alignment for the enclosure is achieved. Follow the steps below carefully.
Align the enclosure over the deck's bolt holes, note that these holes are threaded. Prepare the enclosure bolts. Add a metal washer and rubber washer to each bolt. The order of parts when assembled should be bolt, metal washer, rubber washer, enclosure. Add a drop of loctite to each bolt!
Add the bolt to the left side, second from the top (red circle). Do not tighten it fully, get the threads started (loctite)
Then add the bolt to the other side (right red circle). Do not tighten fully. You may need to provide some force to move the enclosure towards the bolt holes as shown in the second photo (loctite)
Then add the two bolts in the orange circles (loctite)
Add the bolts to the yellow circles (loctite)
Finally add the bolts to the green circles
After all bolts are started, tighten them in the same order to the point where the rubber washer is compressed, but not misshapen. If you cannot get a bolt to start threading, remove all of the bolts. Then start with the bolt that wouldn't start threading and continue adding all of the bolts.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.